Sanctuary Keypad Functions:
- Lock the entire keypad: Press the INSIDE button for 5 seconds and it will lock the entire keypad. Press the INSIDE button again for 5 seconds to unlock the keypad.
- Lock everything but the lights: Press the OUTSIDE button for 5 seconds and it will lock the entire keypad except the lights. Press the OUTSIDE button again for 5 seconds to unlock the keypad.
- Reservation mode: “Reservation” button is for pre-setting the time you want your sauna to turn on. Press RESERVATION button once. Pre-set the time you want your sauna to turn on with the UP/DOWN ARROWS. TEMP UP/DOWN ARROWS are for hour setting and TIME UP/DOWN ARROWS are for minute setting. The setting range is 00:00-25:59. Once selected, waiting about 3 seconds, the time will stop flashing, then the reservation is finished. If you want to cancel or re-reservation, just press the “Reservation” button one more time.
- Front Outlet for Red Light Commercial Mode: With the POWER on, set the temperature to 40C and press the AUX button for 5 seconds for Commercial Mode. The outlet works for 30 minutes.
- Front Outlet for Red Light Residential Mode: With the POWER on, set the temperature to 50C and press the AUX button for 5 seconds for Residential Mode. The outlet is always on.
- Front Outlet for Add On Full Spectrum Heater: With the POWER on, set the temperature to 60C and press the AUX button for 5 seconds. The outlet works with the other heaters in the sauna.
- 16 Hour Continuous Operation Mode: With the POWER on, set the temperature to 10C and press the AUX button for 5 seconds. The sauna will now run for 16 hours. You can continue to adjust the time between 0-60 minutes and it will count down, but the sauna won’t shut off when it reaches 0. To turn off 16 hour mode, press the POWER button.
- R6: The R6 error code is a memory error in the keypad. It can happen if there is a power surge/fluctuation. To clear the error, hold the Time Down button for 10 seconds. That will clear the error.
- WiFi Status: With the POWER off, press the FS button for 3 seconds. This shows the WiFI strength in the TEMP area of the display and it shows the WiFi connection state status in the TIME area of the display. This will stay on for 10 seconds.
- Check WiFi Status: Press the POWER button for 5 seconds. It will start the WiFi Configuration Mode. This shows the WiFI strength in the TEMP area of the display and it shows the WiFi connection state status in the TIME area of the display. This will stay on for 2 minutes:
- wifi_state=0: It cannot find WiFi mode
- wifi_state=1: The WiFi could not connect to the router
- wifi_state=2: The WiFi connected to the router but could not connect to the iCloud server
- wifi_state=3: The Wifi connected to both router and to the iCloud server successfully and all should be working correctly